MOWER DECK
6. Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter (Fig. 415).
C
A. Front support rod
B. Locking nut
6
7. Install the mower belt onto the engine pulley; see
"Mower Belt Replacement" on page 6-18.
6-14
B
A
Fig. 415
C. Hairpin cotter and
clevis pin
Leveling the Mower Deck
Check to ensure the mower deck is level whenever the
mower is installed or there is poor cutting performance.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed and
replaced. See "Checking for Bent Blades" on page 6-20
before continuing.
the front to rear slope can be adjusted.
Requirements:
"Checking the Tire Pressure" on page 6-21.
TimeCutter® Z/Precision® Z Service Manual