Toro Lawn-Boy TimeCutter Z Service Manual page 139

MOWER DECK
6. Move to the left side of the machine. Loosen, but
do not remove, the rear locking nut on the hanger
bracket (Fig. 418).
C
F
A. Hanger bracket
B. Rear locking nut
C. Side locking nut
6
D. Eccentric adjustment plate
7. Loosen the side locking nut on the hanger bracket
just enough to allow the eccentric plate to be ad-
justed (Fig. 418). Use a 3/8" drive extension on a
socket wrench to manipulate the eccentric plate. Use
the wrench to reposition the height of the mower
deck and adjust to the desired height.
8. Stop the deck at the adjusted position and tighten
the side locking nut on the hanger bracket to hold
the new position (Fig. 418). Tighten the rear locking
nut on the hanger bracket.
9. Continue leveling the deck by checking the front-to-
rear blade slope; see "Adjusting the Front-to-Rear
Blade Slope" on page 6-16.
6-16
D
A
B
E
Fig. 418
E. Socket wrench hole
F. Socket wrench with 3/8"
extension
Adjusting the Front-to-Rear Blade Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than 5/16"
(7.9mm) lower than the rear of the mower, adjust the
blade level using the following instructions.
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the park
position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
Note: Check and adjust the side-to-side blade level
TimeCutter® Z/Precision® Z Service Manual