Toro Lawn-Boy TimeCutter Z Service Manual page 140

4. Carefully rotate the blades so they are facing front to
rear (Fig. 419 and Fig. 420).
B
A
Fig. 419
Mower Decks with 2 Blades
A. Blades front to rear
C
B
Fig. 420
Mower Decks with 3 Blades
A. Blades front to rear
TimeCutter® Z/Precision® Z Service Manual
B
B. Measure from the tip
surface here
B
A
C
C. Measure from the tip
surface here
MOWER DECK
(Fig. 419 and Fig. 420). If the front blade tip is not
1/16 - 5/16" (1.6 - 7.9mm) lower than the rear blade
tip, adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Fig. 421).
A
Fig. 421
A. Adjusting rod
B. Adjusting block
7. To raise the front of the mower, tighten the adjust-
ment nut. To lower the front of the mower, loosen the
adjustment nut.
8. After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip is
1/16 - 5/16" (1.6 - 7.9mm) lower than the rear blade
tip (Fig. 419 and Fig. 420).
9. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again; see "Side-
to-Side Leveling" on page 6-15.
C
B
C. Lock nut
6-17
6