Table of Contents
Advertisement
4. Getting Started
The background image of the startup screen and info screens can be changed with Projector Toolset with an
installed F80 plug-in.
Description
Plug the 3-prong plug of power cord into a grounded AC outlet. The projector will go to READY mode. During this stage the system
boots and performs the internal check of the boards. The Power On/Off button will BLINKING WHITE until READY mode is achieved.
Once in READY mode, the Power On/Off button will be lit WHITE.
4.3.3
Going from READY to ON
Description
Press the Power On/Off button on the projector, or the Power On button on the remote control. The projector will power ON. The
Power On/Off button will BLINK BLUE during the transition from READY to ON. Once the projector is on, the Power On/Off button
will be lit BLUE.
4.3.4
Going from ON to READY
Description
Press the Power on/off button on the projector, or the Power On button on the remote control. The projector will power down through
a cool down phase. The Power on/off button will BLINK WHITE during the transition from ON to READY. Once the projector is in
READY, thePower on/off button will be lit WHITE.
4.3.5
Going from READY to ECO standby
Description
If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby ECO", in User Guide) the
projector will automatically go to ECO standby mode after a time-out (default 15 minutes). All electronics (including fans, pumps,...)
go down except for a very small wake up controller. The Power on/off button will FLASH WHITE every second.
4.3.6
Going from ECO to ON
Description
Press the Power on/off button on the projector, or the Power On button on the remote control or do a wake on LAN. The projector
goes from ECO directly to ON. The projector will go through the same booting phase as on power plugging, then do the transition
from READY to ON. Of course startup-time will be longer then from READY to ON.
4.4
Status overview
Description
Once the projector is started, press Status to get an overview of parameters such as :
•
Chosen source
•
Current resolution and refresh rate
•
Device serial number and article number
•
Current firmware version and model name
•
Current illumination (in percentage)
•
Lamp runtime in hours
•
Chosen communication method and IP address (if connected)
•
Warp status
•
Environmental temperature
26
R5906852 F80 SERIES 21/09/2017
Advertisement
Table of Contents
