Remote Control, On/Off Button; Enable / Disable Remote Control; Wired Rc Connection - Barco F70 Series User Manual

Getting to know the projector.

2.7.4 Remote control, on/off button

Purpose of the remote control on/off button
The Pulse remote control unit has at the front side an on/off switch (reference 1 Image 2-8). Switching off the
remote control prevents that unwanted commands are send due to an accidental key press. Furthermore,
switching the RCU off will extend the battery life time of the remote control.
To activate the remote control press the on/off button.
To deactivate the remote control press the on/off button again.
Default when (re)placing batteries, is "ON".
Image 2-8

2.7.5 Enable / Disable Remote Control

About
This function are for disabling the IR sensors for the remote control. Either front or rear, or both.
Image 2-9
• Select the menu path Home/System Settings/Communication/IR control
• Select which sensors to be disabled.
• Enter the Apply button to confirm the action
When all sensors are turned off, the projector will not receive any signals from the remote control.
To enable the sensors again, use the keypad on the projector.

2.7.6 Wired RC connection

About
The remote control can also be directly wired to the projector from the stereo jack connector on the remote,
(See "Functionality overview", page 33 ), to the RC connector on the back panel of the projector.(See section
"Connector Panel")
In this mode, the projector will not be affected by signals from other non-wired remote controls.
34 601–426-03 F70 Series
1