GUI – Macro's and projector profiles
13.1 Saving the current projector settings in a
profile
Which settings can be saved to a profile?
Profile setting
name
Source
Image
PQ (HDR)
Realcolor P7
Installation
Warp
Blend
Black level
Illumination
Display (3D
settings)
Cooling
3
How to save the current projector settings?
1.
In the main menu, select Profiles → Edit.
3.
Only if external cooler is installed
154
R5906070 /16
HDX 4K
Settings saved
Active source selection & EDID
•
All basic image settings: contrast, brightness, saturations, sharpness & gamma
•
Used gamma type
•
Digital zoom (width / height / factor + enabled/disabled)
•
Digital shift (x / y + enabled / disabled)
•
Output resolution
Screen luminance & HDR boost value
Color mode & P7 coordinates
•
Lens parameters (lens zoom, focus & shift)
•
Orientation (mounting & projection)
•
Scaling mode
•
Position of motorized frame (if used).
•
Shutter status (open or closed).
•
Warp status enabled / disabled
•
Screen size
•
Warp file selected (if available)
•
Transport delay
Note: Bow and 4 corners warp cannot be saved.
•
Blend mask enabled / disabled
•
All Masks (top / bottom / left / right) and heights (top / bottom / left / right)
•
Blend files enabled / disabled (if available)
•
Blend file selected (if available)
•
Black level file enabled / disabled
•
Black Level file selected (if available)
•
Basic black level enabled / disabled
•
Black level settings (top / bottom / left / right)
•
RGB gain values (Red, Green and Blue values)
•
Power setting
•
CLO enabled / disabled
•
CLO set point
•
Display mode used
•
Swap eyes on / off
•
Swap frame pair on / off
•
Dark time and sync delay values
Selected Cooling mode