Potting Instructions; Base Dimensions And Wiring Diagrams - Bennett 3000 Series Installation & Operator's Manual

1. Install field conduit dispenser per NFPA-70 along with any state
and local codes.
2. Pull field wiring allowing 72" of extra wire to reach upper electrical
enclosure.
3. Feed wire through conduit and into upper electrical enclosure.
CAUTION: Don not damage wire while feeding through
conduit into the upper electrical enclosure.
4. Wrap some "CHICO X" fiber around wires and push into conduit
assembly to prevent potting from running down the length of the
conduit. See figure.
5. Using the wire separator provided, install one wire in each hole
until all wires are separated. See Figure.
6. Shorten field wiring
connections.
7. Attach field wiring to terminal strip in upper electrical enclosure
according to the wiring diagram supplied for this dispenser. See
Figure.
8. Push wire separator at least 3/4" into conduit.
9. Prepare potting compound according to directions.
NOTE: Use "CHICO A3" potting compound for sealing
fittings in hazardous locations.
10. Using a funnel, pour potting into conduit, be sure to get potting in
between each wire. See Figure.
11. Let stand until firm.
Footprint Dimensions and Wiring Diagrams
Find the appropriate footprint dimensional drawings and wiring diagram for the model of dispenser being
installed in the next section of this manual. Read and follow all directions and safety notices.
WARNING: RISK OF ELECTRICAL SHOCK – More than one disconnect switch may be required to de
-energize the device for serving.
Note - Dispenser electrical disconnect must comply with National Electrical Code, NFPA 70.
WARNING: All doors must be replaced and locked when unit is in service.
WARNING: EXPOSED BELTS AND PULLEYS. Do not operate pump with door removed except
when required for maintenance and then only by a Bennett Authorized Service Representative. Keep
clear of belts and pulleys.

Potting Instructions

to appropriate length
28
when making
107929 Rev E 04-24-17