Table of Contents
Advertisement
147193 DEF 100-200 Installation Manual
Installation Instructions
SECTION 3: INSTALLATION INSTRUCTIONS
Bennett Pump Dispensers are to be installed by trained technicians. All technicians must be aware of ALL safety instructions. If you are
not a Bennett trained technician, please contact Bennett Technical Support at 1-800-423-6638 for training information.
UNLOADING, UNPACKING AND PROPER ST ORAGE
Bennett dispensers are bolted to a pallet and then carefully packaged with cardboard/styrofoam liners and in a
cardboard exterior carton. The entire package is then securely wrapped with plastic shrink wrap. Use a fork lift to
transport the dispenser while it is still on the pallet.
Before signing the freight delivery receipt, inspect the carton and pallet for any obvious signs of damage to the
dispenser. If any damage is found with the product, instruct the delivery driver to make a notation on the delivery
receipt before signing. If possible, open the carton and inspect the dispenser before signing the delivery receipt.
Bennett dispensers are shipped F.O.B. This means that the title to the equipment passes to the purchaser at the
time the equipment is loaded on the truck at our factory. Freight damage claims are the responsibility of the
purchaser. Bennett will assist in preparing any damage claim, by helping to identify and price any parts
necessary to make needed repairs.
Carefully remove the plastic shrink-wrap from the carton. Then carefully remove the cardboard container and any
inside liners. DO NOT DISCARD THE PACKAGING. Should the need arise to repackage the dispenser, the
cardboard packaging can be reused. Plastic shrink-wrap can be purchased at office supply stores or industrial
packaging stores.
Examine the exterior panels for any signs of freight damage. If shipping damage has occurred after signing for
delivery, call the freight carrier immediately and request an inspection. DO NOT DISCARD THE PACKAGING;
the inspector will want to examine it.
If there is no freight damage to the exterior of the dispenser, use the door key (wire tied to the nozzle hook) to
unlock the upper door. Remove the lower panel from the dispenser. Visually examine the interior of the dispenser
for shipping damage. While the dispenser is extremely sturdy, a dispenser that has been "dropped" can suffer
damage internally even while it appears normal on the exterior.
Read the model/serial plate of the dispenser and check to confirm that the hydraulic configuration is what your
order specified.
Report any non-shipping related problems to Bennett Customer Service:
In USA, telephone (800) 423-6638 or outside the USA, telephone (231) 798-1310; or via FAX to (231) 799-6202;
or via email to techhelp@bennettpump.com. Or write to us at:
Bennett Pump Company
1218 E. Pontaluna Road
Spring Lake, Michigan, USA 49456
After freight inspection, it is extremely important to store the new dispensers in a heated building prior to
installation. Bennett factory test all units with de-ionized water prior to shipment. If stored in an environment that
is below freezing (32° F.), internal components will freeze or crystallize. This will cause damage to the internal
hydraulics at startup if these guidelines are not followed. Any damages related to improper storage are not
covered under the Bennett Limited Warranty for DEF dispensers.
7
Advertisement
Table of Contents
