Lifting A New Dispenser And Placing It On The Island - Bennett 3000 Series Installation & Operator's Manual

Lifting a New Dispenser and Placing it on the Island

The dispenser is bolted to a pallet with bolts and nuts. With the lower doors removed and safely stored
away, remove the nuts and bolts that secure the dispenser to the pallet.
Unlock the lower door with the keys that
come with the unit. Swing the door open
90 degrees and lift.
Fig. 1 - Side View - Using lifting straps to lift
and move the dispenser. Notice the forks
are spread wider than the pump.
Thread two lifting straps (900 lbs. Capacity each minimum) through the dispenser as shown in Figures 1
and 2. Be careful not to allow the straps to go under any of the hydraulic castings such as the meter
outlet, copper tubes or valves. The straps should be lifting only against the front and rear chassis. Use
a forklift or pallet lifting device with the forks spread wider than the pump and gently lift the dispenser.
This lifting method will also work on the high hose dispenser. Place the dispenser gently on the island
using care to line up the base anchor bolt holes with the anchor bolts embedded in the concrete island.
WARNING: Lift only to the height required to set the dispenser on the island. Keep hands and
feet clear of the dispenser while it is suspended in the air.
Remove the door and store in a safe place
until you are ready to put the door back
Fig. 2 - Front View - Using lifting straps to lift
and move the dispenser.
10 107929 Rev E 04-24-17