Determining The Number Of Product Supply Pipes Needed - Bennett 3000 Series Installation & Operator's Manual

Determining the Number of Product Supply Pipes Needed

Step 1: Determine the type of supply line needed from the model number's 7th position on the
serial tag. If the model number is 3111SNR (Note the R) the dispenser will require a submerged pump
and pressurized supply line for each product. If the model number is 3111SNS (Note the S) the pump
will require a suction supply line for each product.
Step 2: Determine the number of product pipes required by finding the model number below.
Model Number Product Supply lines required
3111 Use 1 Product Line plumbed to position 1
3211 Use 1 Product Line plumbed to position 1
3311 Use 1 Product Line plumbed to position 1
3411 Use 1 Product Line plumbed to position 1
3511 Use 1 Product Line plumbed to position 1
3611 Use 1 Product Line plumbed to position 1
3112 Use 1 Product Line plumbed to position 1
3212 Use 1 Product Line plumbed to position 1
3312 Use 1 Product Line plumbed to position 1
3412 Use 1 Product Line plumbed to position 1
3512 Use 1 Product Line plumbed to position 1
3612 Use 1 Product Line plumbed to position 1
3122 Use 2 Product Lines plumbed to positions 1 & 2
3222 Use 2 Product Lines plumbed to positions 1 & 2
3322 Use 2 Product Lines plumbed to positions 1 & 2
3422 Use 2 Product Lines plumbed to positions 1 & 2
3622 Use 2 Product Lines plumbed to positions 1 & 2
*Refer to base drawings in the back of this manual for product inlet locations.
Pipe Size - 1-1/2 " inlet nipples come on all units.
1-1/2" nipple.
14 107929 Rev E 04-24-17