Bennett 3000 Series Installation & Operator's Manual page 25

1. Remove nozzle from the dispenser's nozzle boot.
2. Insert nozzle fully into the vehicle fill pipe.
3. Rotate the Reset Handle (small handle)

The computer or non-computer dials will reset to zero.
4. Rotate On-Off Lever fully to the "On" position .

The self-contained pump's motor will turn on or if it is a remote dispenser you will hear
the electric solenoid valve click open.
5. Squeeze the nozzle lever and dispense the desired amount of fuel. Some nozzles will be
automatic shut-off style and may be equipped with a latch open device, which can be set at
several flow rate points. If the nozzle is not equipped with a latch open device, you must hold
the nozzle lever open. DANGER: Do not attempt to block open the nozzle lever with any
foreign objects.
DANGER: The operator must remain in view of the nozzle at all times while the dispenser
is on or while the nozzle is removed from the dispenser's nozzle boot.
6. When the desired amount of fuel has been dispensed into the vehicle, close the nozzle.
7. Turn the dispenser's on/off handle to the "Off" position.
8. Return the nozzle to the nozzle boot of the dispenser.
9. Replace the vehicle's fuel cap.
DANGER: No not dispense fuel into unapproved containers.
Cam Reset Activation
25 107929 Rev E 04-24-17