Operator Instructions - Bennett 3000 Series Installation & Operator's Manual

DANGER: Gasoline is flammable.
NO SMOKING OR OPEN FLAME WITHIN 100' OF THE EQUIPMENT.
DANGER: Fire, explosion, injury or death will occur if untrained personnel change fuel filters.
Make sure only trained personnel change filters.
The Bennett mechanical computing fuel dispenser is simple to operate:
ELECTRIC RESET ACTIVATION
1. Remove nozzle from the dispenser's nozzle boot.
2. Insert nozzle fully into the vehicle fill pipe.
3. Rotate On-Off Lever fully to the "On" position .

The electric reset will turn on (you can usually hear the reset motor running)

The computer or non-computer dials will reset to zero.

The self-contained pump's motor will turn on or if it is a remote dispenser you will hear the
electric solenoid valve click open.
4. Squeeze the nozzle lever and dispense the desired amount of fuel. Some nozzles will be
automatic shut-off style and may be equipped with a latch open device, which can be set at
several flow rate points. If the nozzle is not equipped with a latch open device, you must hold
the nozzle lever open. DANGER: Do not attempt to block open the nozzle lever with any
foreign objects.
DANGER: The operator must remain in view of the nozzle at all times while the dispenser
is on or while the nozzle is removed from the dispenser's nozzle boot.
5. When the desired amount of fuel has been dispensed into the vehicle, close the nozzle.
6. Turn the dispenser's on/off handle to the "Off" position.
7. Return the nozzle to the nozzle boot of the dispenser.
8. Replace the vehicle's fuel cap.
DANGER: No not dispense fuel into unapproved containers.

Operator Instructions

24 107929 Rev E 04-24-17