T1/E1 Mode Dip-Switch - ADTRAN NetVanta 4305 Hardware Installation Manual

NetVanta 4305 Hardware Installation Guide
Clock Source
• Network
• Internal
Diagnostics
• Network Loopbacks: Line, payload, remote
• Test Pattern Generation and Detection: QRSS, 2
Compliance
• EMC - see Electromagnetic Compatibility (EMC) Table on page 6
• AS/ACIF S016
• ETSI TBR 12/TBR 13
• ACTA/FCC Part 68
• IC CS-03
• UL/CUL 60950
• EN 60950
• IEC 60950
• AS/NZS 60950
• RoHS Compliant (1202843E1 only) (Telecommunications exemption)
Environmental
• Operating Temperature: 0°C to 50°C
• Storage Temperature: -20°C to 70°C
• Relative Humidity: 95 percent, noncondensing
Physical
• 5.63-inch W x 8.63-inch D
No external CSU/DSU is needed with the T1/FT1 interface.

T1/E1 Mode Dip-Switch

The T1/E1 Wide Module is shipped with the T1/E1 mode switch (located on the circuit board) set to T1. If
you require E1 functionality, use your thumbnail to slide the E1 mode switch to the
in the figure below).
61200890L1-34H
15
- 1, 511, all ones, all zeros
Switch Set to T1 Mode
Switch Set to E1 Mode
Copyright © 2006 ADTRAN, Inc.
Option Modules
position (as shown
ON
31