PortVision DX Overview
DeviceMaster UP 16-Port Hardware User Guide: 2000596 Rev. B
Configuring the DeviceMaster UP
The DeviceMaster UP platform includes PortVision DX, which is the management
application that you use to manage all Comtrol Ethernet-attached devices.
Note: Existing installations: PortVision DX replaces PortVision Plus, you must
install PortVision DX v3.02 or higher to upload the latest firmware.
This section contains these topics:
•
PortVision DX Overview
•
•
•
•
•
•
•
Note: If PortVision DX is already installed, go directly to
Settings
on Page 16 to change the IP address on the DeviceMaster UP.
PortVision DX automatically detects Comtrol Ethernet-attached products
physically attached to the local network segment so that you can configure the
network address, upload firmware, and manage the following products:
•
DeviceMaster family
-
DeviceMaster PRO
-
DeviceMaster RTS
-
DeviceMaster Serial Hub
-
DeviceMaster UP
-
DeviceMaster 500
•
DeviceMaster LT
•
IO-Link Master
•
RocketLinx switches
In addition to identifying Comtrol Ethernet-attached products, you can use
PortVision DX to display any third-party switch and hardware that may be
connected directly to those devices. All non-Comtrol products and unmanaged
RocketLinx switches are treated as non-intelligent devices and have limited
feature support. For example, you cannot configure or update firmware on a third-
party switch.
Configuring the DeviceMaster UP - 11
Configuring the Network