Resetting The Devicemaster; Configuring Passwords - Comtrol DeviceMaster MOD Series Hardware Installation And Configuration Manual

Table of Contents

RedBoot Procedures

Resetting the DeviceMaster

76 - RedBoot Procedures

When you have completed your tasks in RedBoot, you must enter a reset command

at the RedBoot> prompt for the DeviceMaster to begin operation.

Note: The

LEDs

on the DeviceMaster will go through the power up sequence. The

DeviceMaster has completed its reset cycle when the Status LED is lit and it

stops flashing.

RedBoot> dis

Loading disabled

RedBoot> reset

This section discusses how to configure a password for the web and telnet server.

Use the following procedure to establish the DeviceMaster password for the Web

and telnet server. Establishing a password prevents unauthorized changes to the

DeviceMaster configuration.

1. Establish communications with the DeviceMaster using the serial (Page 72) or

telnet method (Page 73).

2. Type password [your_password] and press Enter.

Note: If you forget your password, you can reprogram the password using the

serial method which bypasses the password.

Note: The Bootloader version on your DeviceMaster may be different than the

version displayed in this graphic.

See the auth command in the

to set up Web browser authentication.

DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B

RedBoot Command Overview

on Page 77, if you want

Table of Contents