Managing The Devicemaster; Rebooting The Devicemaster - Comtrol DeviceMaster MOD Series Hardware Installation And Configuration Manual

Rebooting the DeviceMaster

DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B

Managing the DeviceMaster

This section discusses the following DeviceMaster maintenance procedures:
• Rebooting the DeviceMaster
• Uploading Firmware to Multiple DeviceMasters
• Configuring Multiple DeviceMasters Network Addresses
Note: You can configure the network addresses for multiple DeviceMasters,
configure common settings for the DeviceMasters, and save the settings
to a configuration file that you can use to load settings up to all or
selected DeviceMasters.
• Adding a New Device in PortVision DX
• Managing Bootloader
Bootloader version and downloading the latest Bootloader
• Restoring Factory Defaults (Specific Models)
• Accessing RedBoot Commands in Telnet/SSH Sessions (PortVision DX)
Page 68
Note: You can optionally refer to
perform procedures at the RedBoot level.
There are many ways to reboot the DeviceMaster.
Method
Right-click the DeviceMaster or DeviceMasters in the Device
List pane, click Advanced >Reboot and then Yes.
PortVision DX
Note: If security has been enabled in the web page, you will
System | Reboot: You have 10 seconds to Cancel before the
Web page DeviceMaster automatically reboots. Optionally, you can click
Reboot Now.
Telnet Type reset.
DeviceMaster DIN rail models have a Reset/Restore switch.
• If the Reset/Restore switch is depressed for less than 2
DeviceMaster seconds, the DeviceMaster reboots.
DIN Rail Models
• If the Reset/Restore switch is depressed for greater than
approximately 5 seconds it restores the DeviceMaster to
the factory default values.
on Page 63
on Page 65, which also discusses checking the
on Page 67
RedBoot Procedures
Procedure
need to reboot the DeviceMaster in the web page.
on Page 62
on Page 63
on Page 71 if you want to
Managing the DeviceMaster - 61
on