Port Setup - 3Com 3C16630A User Manual

3-36 C 3: U
HAPTER
Media Type This field indicates the media type of the port. See
Types"
Source Address Changes This field shows the number of different
source addresses that have been received at this port. If there is
normally only one device connected to each port, it will allow you to
monitor unauthorized devices connected to the network.
Last Source Address This field shows the source MAC address of the
last frame received at this port.
CLEAR COUNTERS (Button) For users with an access level of manager
or higher. Move the cursor to this button and press [Return] to reset all
the port statistics counters to zero. Clearing the port's counters affects
the statistics viewed by all users.
CANCEL (Button) Move the cursor to this button and press [Return] to
go back to the Repeater Management screen.

Port Setup

You access the Port Setup screen from the Repeater Management
screen, by selecting management level Port then actuating the SETUP
button. The Port Setup screen allows you to configure a selected port.
The screen is illustrated below.
Figure 3-22 Port Setup Screen
VT100 M
SING THE
on page 3-37.
3Com SuperStack II Port Setup
Unit ID:
Port ID:
Media Type:
Port State:
Security:
Link Pulse:
Link State:
Lost Links:
Partition State:
OK
I
ANAGEMENT NTERFACE
2
1
Twisted Pair (10BaseT)
Enabled
Enabled
Enabled
Not Available
0
Not Autopartitioned
CANCEL
"Media
DUA1663-0BAA03