Repeater Setup - 3Com 3C16630A User Manual

3Com SuperStack II Repeater Statistics
Good Frames:
Good Octets:
Unicast Frames:
Multicast Frames:
Broadcast Frames:
Transmit Collisions:
Runt Frames:
AutoPartitions:
Bandwidth Used (%):
Figure 3-16 Repeater Statistics Screen
The screen is updated every 3 seconds. If the top limit of a counter
(4294967295) is reached, the counter will roll-over (reset to zero
automatically). After this event, the individual figures may give a false
impression of network conditions if taken in isolation.
All the fields are read-only. Refer to
description of the statistics fields.
CLEAR COUNTERS (Button) This button is shown only for users with an
access level of manager or higher. Select this button and press [Return]
to reset all the statistics counters on the repeater to zero. Clearing the
repeater counters affects all users, and clears the counters for all the
units and ports on this repeater.
CANCEL (Button) Select this button to go back to the Repeater
Management screen without clearing the counters.

Repeater Setup

You access the Repeater Setup screen from the Repeater Management
screen, by selecting management level Repeater then actuating the
SETUP button. The Repeater Setup screen shows the current
configuration of the repeater (stack).
DUA1663-0BAA03
345
123456
34560
7
2
0
5
0
0
CLEAR COUNTERS
Repeater Management
FCS Errors:
Alignment Errors:
Short Events:
Too Long Frames:
Very Long Events:
Data Rate Mismatches:
Late Events:
Total Errors:
Errors/10000 Packets:
CANCEL
Appendix D for a detailed
3-27
10
0
0
0
1
0
0
11
0