Table of Contents
Advertisement
2-2
C
2: I
HAPTER
Module"
module.
To complete the installation, you will need a small cross-bladed
screwdriver. The installation comprises the following steps:
Unpack the Hub 10 Module from the carton.
Disconnect all the units in the stack from the mains power supply.
Disconnect the unit into which you will fit the module from the other
units.
Position the unit so that you have enough space in which to work.
Remove the blanking plate from the rear panel.
Insert the module and connect it to the unit.
Reinstall and power up all the units in the stack, as described in the
section
Unpacking
Remove the Hub 10 Module from its packaging, taking care not to
touch any of its components or connectors. In addition to this manual,
the package should contain:
The Hub 10 Module (as ordered)
1x M2.5x25 cross-head screw and crinkle washer
If any of these items are missing, please contact your supplier.
Disconnecting the Unit
1 Disconnect all the units in the stack from the mains power supply.
Warn any network users connected to the repeater before you power
down the units.
2 Disconnect the unit into which you will fit the module from the other
units in the stack. If necessary, move the unit so that you have
sufficient space to work.
S
NSTALLATION AND
ETUP FOR
on page 1-15 lists the units into which you can install the
"Power Up Sequence"
M
ANAGEMENT
on page 2-6.
DUA1663-0BAA03
Advertisement
Table of Contents
