Unit Setup - 3Com 3C16630A User Manual

Unit Setup

You access the Unit Setup screen from the Repeater Management
screen, by selecting management level Unit then actuating the SETUP
button. The Unit Setup screen is illustrated below.
Unit ID:
Unit Type:
Unit Hardware Revision:
Unit Port Capacity:
Unit Boot State:
Active Power Supply:
Power Supply Status:
Transceiver Module:
Figure 3-20 Unit Setup Screen
The Unit Setup screen provides read only information. It shows how
the unit has been set up, and the physical configuration of the unit at
the time you display the screen. Changes made after the Unit Setup
screen is displayed are not shown until the next occasion you display
the screen.
Unit ID This field shows the identifier of the unit you have selected.
This should be the same as that indicated by the Unit LED on the front
of the chosen unit. The unit fitted with the Module is always unit 1.
Unit Type This field displays the product name or specification of the
chosen unit.
Unit Hardware Revision This field indicates the hardware revision of
the unit. You may need to quote this number to your supplier's
technical support service in the event of a problem.
Unit Port Capacity This field indicates the maximum number of ports
supported by the selected unit.
DUA1663-0BAA03
3Com SuperStack II Unit Setup
CANCEL
Repeater Management
2
SuperStack Hub 10 12 port TP
2
13
All Ports Enabled
Internal
OK
AUI
3-33