The Superstack Ii Hub 10 Rmon Implementation - 3Com 3C16630A User Manual

Management module/advanced rmon module
Table of Contents

Advertisement

E-4
A
PPENDIX

The SuperStack II Hub 10 RMON Implementation

The following table summarizes the support in this product for the nine
standard groups of RMON. The table also specifies the configuration of
the various groups after system initialization.
Table E-1 RMON Group Configurations
Group
Initial Configuration
Ethernet
1 session monitoring the Ethernet repeater traffic.
Statistics
Stats History
3 default sessions:
a) 60 second interval,
120 historical samples stored.
b) 30 second intervals,
120 historical samples stored.
c) 30 minute intervals,
96 historical samples stored.
Host Table
1 session collecting host information.
Matrix Table
1 session collecting matrix information.
Host top 'N'
No default topN groups.
Alarm
Default alarms are configured at startup.
Event
Default events exist to describe our 'action-on-event'
system. User can create new events.
Filter
Full packet filter is supported.
Capture
Full packet capture is supported on the Module.
After the default sessions are created, they have no special status. The
user can delete or change these parameters as required.
Two default alarms are created initially. These are bandwidth used and
errors /10000 packets. These can be deleted or changed as required.
RMON, in the SuperStack II implementation, is a very user configurable
system. The user can create multiple monitoring facilities to run in
parallel. Examples of these facilities may be:
E: RMON
A
AND
DVANCED
M
ANAGEMENT
Effect of Power
Cycle on
Configuration
configuration lost
configuration lost
configuration lost
configuration lost
configuration lost
configuration
restored
configuration
restored
configuration lost
configuration lost
DUA1663-0BAA03

Advertisement

Table of Contents
loading

Table of Contents