Remote Poll - 3Com 3C16630A User Manual

3-44 C 3: U
HAPTER
When you configure a resilient link pair, the management facility will
automatically enable Link Pulse generation (see
page 3-36) for both ports. If you subsequently delete the resilient link
pair, Link Pulse generation remains enabled.
DELETE (Button) Move the cursor to this button and press [Return] to
delete the resilient link pair specified by the Main Unit ID, Main Port ID,
Standby Unit ID and Standby Port ID fields. You will be asked to press
[Return] again for confirmation.
CANCEL (Button) Move the cursor to this button and press [Return] to
go back to the previous screen (either the Repeater Management
screen or the Repeater Resilience screen).

Remote Poll

The Remote Poll screen allows you to see if a remote device is
responding, by sending a message forcing a response from the target
device. This will determine if there is a path or a congested path
between this device and other devices on the network. To display the
screen, actuate the REMOTE POLL button on the Main Menu screen
(only available to users with manager access level or higher.)
Target Address :
Round Trip Time :
This operation will poll the target device.
IP address format
IPX address format
Figure 3-24 Remote Poll Screen
VT100 M
SING THE ANAGEMENT
3Com SuperStack II Remote Poll
POLL
I
NTERFACE
[11223344:112233445566]
30 (milli-seconds)
2 Router Hops
d.d.d.d
AABBCCDD:AABBCCDDEEFF
CANCEL
"Port Setup" on
DUA1663-0BAA03