Table of Contents
Advertisement
Configuring the
Serial Port
Configuring
Operation Mode
Configuring UART
Settings
6 Click Apply.
To delete one or more clients from the Access Control List:
1 Select the client or clients.
2 Click Delete.
3 Click Apply.
Under System Configuration, click Serial Port to set up operation of
network serial port or serial telnet client.
Attach your computer to both the Ethernet port and the serial port on the
Bridge, and then configure the Bridge through the computer. Refer to
Table 15 for the available settings.
Table 15 Serial Port Settings
Setting
Operation Mode
Serial Port Mode
A Universal Asynchronous Receiver/Transmitter (UART) is the fundamental
hardware for serial communication, controlling the speed and method of
data transfer of the serial port.
For proper operation, it is imperative that these settings always match the
settings of the device to which the bridge is connected via the RS-232
port. There are two groups of parameters that need to be configured to
accomplish this task: UART Settings and Flow Control Settings.
Flow control is the process of adjusting the flow of data from one device
to another to ensure that the receiving device can handle all of the
incoming data.
Table 16 UART Settings
Setting
Description
Baud Rate
The baud rate indicates the data
transfer rate of the serial port.
Description
Select Enable to enable serial port
function.
Select Disable to enable CLI console
function.
Enable network serial port or serial
telnet client
Configuring the Serial Port
Default
Disable
N/A
Default
9600
45
Advertisement
Table of Contents
