Using The Vt100 Management; Using An Snmp Network Manager - 3Com 3C16630A User Manual

To set up Telnet communications, you first need to connect to the
Module using serial port access and enter certain parameters.
If you wish to use the VT100 interface to set up parameters including
trap addresses, perform the following steps.
1 Connect a VT100 terminal or emulator to the serial port, and logon
using the VT100 interface as described in
2 Display the Setup screen. Enter the Device IP Address and Device
SubNet Mask of the stack, and the Default Router address if necessary,
if you know them. If you have a BootP server on your network and wish
to assign the details automatically, you may use the BootP facility. Refer
to the documentation with your BootP server and
page 3-10 for details of how to do this.
3 Logoff from the VT100 interface.
You can now start a Telnet management session. Make sure that your
Telnet application is emulating a VT100 terminal. To open the Telnet
session, you must specify the IP address of the stack that you entered
in step 2 above. Check the user manual supplied with the Telnet facility
if you are unsure how to do this.
Once the connection is established, you will see the main banner of the
VT100 management interface and you may log on. The VT100
management interface is described in detail in Chapter 3.

Using an SNMP Network Manager

The Transcend WorkGroup and Enterprise Network Management
Applications will enable you to get the best out of your SuperStack II
Hub 10 units. Any SNMP based network manager can manage
SuperStack II Huub 10 and LinkBuilder FMS Series units, provided the
MIB (Management Information Base) is installed correctly at the
management station. The MIB defines what information is available
from the stack through the Module, how that information is structured,
and how the SNMP network manager can read and update it.
The use of 3Com network managers is not described in detail in this
manual. For more information, contact your supplier.
DUA1663-0BAA03
Managing over the Network
"Getting Started"
"Setup"
2-11
on page 3-6.
on