Commissioning Of Optional Units; Insulation Amplifier Pxub 201 - ABB PFEA 113 User Manual

Tension Electronics PFEA113, User Manual
Chapter 3 Commissioning

3.14 Commissioning of Optional Units

3.14.1 Insulation Amplifier PXUB 201

3-48
The insulation amplifier is connected to the tension electronics voltage output.
S1 is normally set for voltage 1:1 ratio.
The output is selected to generate a voltage or current output by means of switch S1 and S2.
Slower response is selected by means of switch S2, position 3.
The switches are located inside the unit.
Top lid
Snap-lock
To release
Figure 3-27. Insulation Amplifier PXUB 201
You must open the insulation amplifier to be able to set the switches S1 and S2.
1. Demount the insulation amplifier from the DIN rail.
Use a screw driver to unload the spring at the bottom of the insulation amplifier.
2. Press down the snap-locks on both sides of the insulation amplifier.
3. Pull the top lid open, until you see both the switches S1 and S2.
Pull out the top lid,
after releasing
the snap-locks.
S2
ON
1 2 3
S1
ON
1 2 3
Spring lock
Snap-lock
3BSE029382R0101 Rev C