Tension Electronics PFEA113, User Manual
Chapter 3 Commissioning
3.12.9 Setting Analog Inputs (AI1 and AI2)
WebTension
> 5 s
FastSetUp
Presentation-
Menu
System-
Definition
ObjectType
SetNominal-
Load
ZeroSet
SetWrapGain
AO 1 - AO 6
DO 1 - DO 4
AI 1 - AI 2
DI
Miscellaneous
Menu
ServiceMenu
3.12.10 Setting the Digital Input
3-34
There are two analog inputs.
The input signal range is 0 to 10 V.
Analog inputs are used to connect two or three PFEA113 together.
To scale the analog inputs the following must be set:
•
High Tension (N, kN, kg, lbs, N/m, kN/m, kg/m, pli)
•
High Input V
AI 1
AI 2
To DI
Figure 3-19. Menus for Analog inputs
See also
Section 3.12.3.3
The digital input is used for Zero Set or Gain Scheduling. The input is set to Off, if not used.
From AI 2
DI
To MiscellaneousMenu
Use up and down keys to select:
•
Off
•
ZeroSet or
•
GainScheduling
HighTension
XXXXXX.X N
HighInput
XX.XX V
HighTension
XXXXXX.X N
HighInput
XX.XX V
for segmented roll application.
Define DI
XX
HighTension
[XXXXXX.X] N
HighInput
[XX.XX] V
HighTension
[XXXXXX.X] N
HighInput
[XX.XX] V
Define DI
[XX]
3BSE029382R0101 Rev C