Menu Overview - ABB PFEA 113 User Manual

3.5 Menu Overview

Operator Menus
TensionRoll 1
N
Tension A
N
Tension B
N
TensionDiff A-B
N
TensionRoll 2
N
Tension C
N
Tension D
N
TensionDiff C-D
N
AO 1 - AO 6
N
Error and
warning messages
1) This menu appears if unit is set to
N/m, kN/m, kg/m or pli.
2) This menu appears if load cell
combination is set to segmented roll.
Depending on load cell combination.
3)
Note! Some sub menus asking
confirmation questions are not
shown in this overview. In these
menus you have to confirm that your
settings should be performed.
3BSE029382R0101 Rev C
Configuration and Service Menus
See Section 4.7.
FastSetUp
> 5 s
Press
See 3.8
Complete
PresentationMenu
setup
See 3.12.1
See Section .
3.11
SystemDefinition
See 3.12.2
ObjectType
See 3.12.3
SetNominalLoad
See 3.12.4
ZeroSet
See 3.12.5
SetWrapGain
See 3.12.6
AO 1- AO 6
See 3.12.7
DO 1 - DO 4
See 3.12.8
See Section 6.6.
AI 1 - AI 2
See 3.12.9
DI
See 3.12.10
Miscellaneous-
Menu See 3.12.11
ServiceMenu
See 3.12.12
Tension Electronics PFEA113, User Manual
The fast setup can be made in two ways
depending on how the wrap gain is set.
Language, Unit, Web Width
number of decimals are set in the presentation
menu.
Select load cell combination and set Segmented
Roll Scale factor (SRSF)
in this menu.
3)
Select Standard roll, Single side measurement or
number of inputs for segmented roll applications.
Check the nominal load on the load cell name
plate. Select nominal load from the list with
. Confirm with
Zero set is used to compensate for load cell zero
signal and tare weight.
Wrap gain can be determined by using hanging
weights or by calculating.
Select Off, U (Voltage), I (Current) or Profibus only.
Connect signals and set filter settings, high and low
Tension, Output and Limit.
Set level detectors (4) and "Status OK"
For connection of multiple electronics.
Select Off, Zero set or Gain scheduling.
This menu is used to set profibus parameters or to
set factory default.
Show PFEA113 software version.
View maximum load and current offset settings for
load cell A, B, C and D.
Reset maximum load memory and offset.
Simulation of load cell signals.
Section 3.5 Menu Overview
1)
and desired
2)
and Gain scheduling
.
or
3-3