Speed Control Pedal; Stopping The Vehicle; Check During Driving; Easy Checker - Kubota RTV520 Operator's Manual

OPERATING THE VEHICLE

8. Speed control pedal

Use the speed control pedal when traveling. Push
down on it for higher speed.
(1) Speed control pedal

STOPPING THE VEHICLE

1. Release the speed control pedal.
2. Step on the brake pedal to slow and stop the
vehicle.
3. After the vehicle has stopped;
a. Put the range gear shift lever in the "NEUTRAL"
position.
b. Set the parking brake.

CHECK DURING DRIVING

IMPORTANT :
Immediately stop the engine if:
• The engine suddenly
accelerates.
• Unusual noises suddenly occur.
• Exhaust fumes suddenly become very dark.
While driving, check the following items to see that all
the parts are functioning normally:
™

• Easy Checker

on page 34
• Fuel gauge on page 35
• Coolant temperature gauge on page 35
• Hourmeter on page 35
™
1. Easy Checker
If the warning lamp in the Easy Checker
during operation, immediately stop the engine, and find
the cause as shown as follows.
Never operate the vehicle with an Easy Checker
on.
34
slows down or
™
comes on
™
lamp
™
(1) Easy Checker
(2) Coolant temperature gauge
(3) Fuel gauge
(4) Hour meter
(5) Electrical charge light
(1) Electrical charge light
(2) Master caution light
™
(3) Easy Checker
Brake indication light
The warning lamp in the Easy Checker
if the parking brake is applied.
If the lamp is on during operation, release the
parking brake lever immediately.
If the brake fluid goes below the prescribed level,
the warning lamp in the Easy Checker
on.
If this should happen during operation, check to see
that there is no oil leak in the brake system, and
then add oil.
(See Checking brake fluid level on page 58.)
Engine diagnostic light
If the engine diagnostic light flashes fast, it is due to
the engine overheating.
If sensors malfunction, the Easy Checker
come on. If the light is active, stop the vehicle and
STARTING THE VEHICLE
(E) "EMPTY"
(F) "FULL"
™
comes on
™
will come
™
will
RTV520