Kubota RTV520 Operator's Manual page 11

• If dust which contains crystalline silica is present,
there are guidelines which should be followed:
– Be aware of the potential health effects of
crystalline silica and that smoking may add to
the damage.
– Be aware of and follow OSHA (or other local,
State or Federal) guidelines for exposure to
airborne crystalline silica.
– Know the work operations where exposure to
crystalline silica may occur.
– Participate in
programs offered by the employer.
– Be aware of and use optional equipment
controls such as water sprays, local exhaust
ventilation, and enclosed CABs with positive
pressure air conditioning, if the machine has
such equipment. Otherwise respirators shall be
worn.
– Where respirators
respirator approved for protection against
crystalline silica containing dust. Do not alter
the respirator in any way. Workers who
use tight-fitting respirators cannot have beards/
mustaches which interfere with the respirator
seal to the face.
– If possible, change into disposable or washable
work clothes at the work site; shower and
change into clean clothing before leaving the
work site.
– Do not eat, drink, use tobacco products, or
apply cosmetics in areas where there is dust
containing crystalline silica.
– Store food, drink and personal belongings away
from the work area.
– Wash hands and face before eating, drinking,
smoking, or applying cosmetics after leaving
the exposure area.
5. Operating on slopes
Slopes are a major factor related to loss-of-control and
roll-over accidents, which can result in severe injury or
death. All slopes require extra caution.
• Travel straight up or down hill.
RTV520
air monitoring or training
are required, wear
SAFE OPERATION
• Reduce load when operating on hilly or over rough
terrain.
• Keep front wheels straight at crest of hill or going
over bumps.
• Do not stop or start suddenly when going uphill
or downhill. Be especially cautious when changing
direction on slopes.
• If vehicle stops or loses power going up a hill, lock
parking brake to hold vehicle on slope. Maintain
direction of travel and release brake slowly. Back
straight downhill while maintaining control. Do not
turn vehicle sideways. Vehicle is more stable in a
straight forward or rearward position.
• When riding on soft terrain, turn front wheels
slightly uphill to keep vehicle on a straight line
across the hill.
• If the vehicle begins to tip, turn front wheels
downhill to gain control before proceeding.
– To avoid upsets, always back up steep slopes.
If you cannot back up the slope or if you feel
uneasy on it, do not operate on it. Stay off
slopes too steep for safe operation.
– Driving forward out of a ditch, mired condition
or up a steep slope increases the risk of a
vehicle to be upset backward. Always back out
of these situations. Extra caution is required
with 4-wheel drive mode because the increased
traction can give the operator false confidence
in the vehicle's ability to climb slopes.
– Keep all movement on slopes slow and gradual.
Do not make sudden changes in speed,
direction or apply brake and make sudden
a
motions of the steering wheel.
– Special attention should be made to the weight
and location of implements and loads as such
will affect the stability of the vehicle.
6. Operation in inclement conditions
• Only operate during daylight or with good artificial
light.
• Operate vehicle in an open, unobstructed area.
• Use helmet and/or protective gear for certain
operating conditions.
• Reduce speed according to trail, terrain and
visibility conditions.
• Never drive exceeding the limit of visibility. Slow
down near crest of hill until getting a clear view of
the other side.
• Stay alert for holes, rocks and other hidden hazards
in the terrain.
• Never cross any body of water where depth may be
unknown to the operator (Deep water is considered
anything in excess the bottom edge of the axle
cap). Choose a course within the waterway where
both banks have a gradual incline. Cross at a point
known to be safe.
7