Operator's Seat; How To Raise The Cargo Bed; Raising And Lowering The Cargo Bed - Kubota RTV520 Operator's Manual

HOW TO OPEN THE HOOD AND TILT THE SEAT

2. Operator's seat

1. To open the seat, raise the seat to the forward
position.
(1) Operator's seat
NOTE :
• For the component below the seat, turn over
the rubber sheet to work on it as shown in
the following figure.
(1) Rubber sheet
HOW TO RAISE THE CARGO
BED
WARNING
To avoid serious injury or death:
• When servicing under raised bed, make sure
safety support is properly mounted.
• Do not touch muffler or exhaust pipes while
they are hot; severe burns could result.
RTV520
(A) Seat
1. Raising and lowering the cargo
bed
WARNING
To avoid serious injury or death:
• Make sure the vehicle is on a firm, level surface
and the parking brake is applied before raising
the cargo bed and securing the cargo bed in the
raised position.
• A loaded cargo bed can be very heavy. Never
raise the cargo bed when it is loaded. Unload
the cargo bed before raising it by hand.
1. Park the vehicle on a flat surface.
2. Empty the cargo bed by hand.
3. Release the latches on both sides and then raise
the cargo bed with the handgrip.
NOTE :
• When the lock is loose or hard, loosen the
bolts and adjust the plate position up or
down on both sides.
Tightening torque (M8): 23.54 to 27.46 N⋅m
(2.40 to 2.80 kgf⋅m) (17.36 to 20.25 ft-lbs.)
(1) Latch
(2) Handgrip
(3) Plate
(4) Bolt
PERIODIC SERVICE
(A) "LOCK"
(B) "RELEASE"
(C) "RAISE"
53