Checking Brake Fluid Level; Checking Brake Pedal - Kubota RTV520 Operator's Manual

PERIODIC SERVICE
5. If the fan will not operate, do not operate the vehicle
and consult with your dealer.
Exceptions in operation
• If the engine coolant temperature is higher than
87 ℃ (188.6 ℉) at startup, the fan will turn
on immediately and run until the engine coolant
temperature is less than 80 ℃ (176 ℉).

8. Checking brake fluid level

WARNING
To avoid serious injury or death:
• Never operate the vehicle if the brake fluid is
below the [MIN] mark.
• Use only KUBOTA DOT3 GENUINE BRAKE
FLUID from a sealed container. Using other
type of oil damages synthetic resin or rubber
installed in brake system components, and may
cause brake failure.
• Avoid contamination
Thoroughly clean the area around the filler cap
before removing. Do not open the fluid tank cap
unless absolutely necessary.
• Use extreme care when filling the fluid tank.
If brake fluid is spilled on the power steering
hose, wash off with water immediately. Brake
fluid quickly damages synthetic resin or rubber
hoses.
1. Park the vehicle on a level surface.
2. Open the hood.
3. Check to see that the brake fluid level is between
the [MAX] and [MIN] marks.
4. If it is below the [MIN] mark, add brake fluid to the
[MAX] mark.
58
of the brake fluid.
(1) Fluid tank cap

9. Checking brake pedal

WARNING
To avoid serious injury or death:
• Stop the engine and chock the wheels before
checking brake pedal.
1. Inspect the brake pedals for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found: (See
Checking brake pedal on page 70.)
(1) Brake pedal
DAILY CHECK
(A) [MAX]
(B) [MIN]
(A) "FREE TRAVEL"
(B) "PEDAL STROKE"
RTV520