Figure 3-9. Removing The Strain Relief Bracket - Nortel Versalar 15000 Installing And Maintaining

3.
Strain
relief bracket
Figure 3-9.
4.
Note: This book refers to the two terminal block sections on the left (Input A)
as VDC-A and RTN-A. The two terminal block sections on the right (Input B)
are VDC-B and RTN-B.
308684-B Rev 00
Using a Phillips screwdriver, remove the 2 screws that secure the strain
relief bracket to the terminal blocks
Removing the Strain Relief Bracket
Using a 5/32 in. hex wrench, loosen the screws on the terminal blocks
(Figure 3-10).
If you are connecting to a single power source, loosen the screws on the two
terminal block sections on the left labeled Input A in
If you are connecting to both power sources, loosen the screws on all terminal
blocks.
Installing Power Supplies
(Figure 3-9).
VRS0053A
Figure 3-7.
3-15