Nortel Versalar 15000 Installing And Maintaining page 111

To connect the Versalar 15000 to the optional AC power unit:
1.
2.
3.
4.
5.
Note: The chassis must be grounded (see Step 11. on
6.
308684-B Rev 00
Make sure that the AC POWER A and AC POWER B power breakers on
the front panel of the separate AC power unit are in the off (0) position.
Make sure that the DC switch on the front right side of the optional AC
power unit is in the off (0) position.
Connect the power cables to the DC power bars on the back of the AC
power unit (Figure
Connect the AC power unit to the DC terminal block (see pages
3-19).
Connect the AC management cable from the 9-pin D-sub connector on
the back of the Versalar 15000 to the separate AC power unit
(Figure 3-15). .
Make sure that the address switch (SW1) on the back of the AC unit is in
the up position (Figure 3-15 on page
3-15).
3-26).
Installing Power Supplies
3-12
page 3-17)
to
3-25