Nortel Versalar 15000 Installing And Maintaining page 40

Installing and Maintaining the Versalar Switch Router 15000
Table 1-8
Table 1-8.
LED
Pwr
Stat
Run
Phy
Sar
Pri IFP
Sec IFP
Link (port n )
1-20
describes the ATM OC-12c/STM TP card LEDs.
ATM OC-12c/STM TP
State
Off
On (green)
Off
On (green)
Flashing (green)
On (amber)
Off
On (green)
Flashing (green)
On (amber)
Off
On (green)
Off
Flashing (green)
On (green)
Off
On (green)
Off
On (green)
Off
On (green)
Card LEDs
Meaning
Power is off.
Power is on.
LED is not functioning.
TP card is operating normally.
Power-up diagnostic testing is in progress.
Diagnostic testing occurs when you cold-start the
module by cycling power, issuing the diags
command from the BCC, or installing the TP card
with the power on.
Power-up diagnostic testing failed. The TP card is
waiting for an automatic attempt to reinitiate
diagnostic testing. If the Stat LED lights amber
again, call the Nortel Networks Technical Solutions
Center.
Processor code is not loaded.
Boot process is complete.
Booting.
A fault is detected. Call the Nortel Networks
Technical Solutions Center.
Trunk interface card is not installed.
Trunk interface card is present.
Not loaded.
Booting.
Boot is complete.
Primary IFP card is not in use.
Primary IFP card is in use.
Secondary IFP card is not in use.
Secondary IFP card is in use.
Frame synchronization is not detected on the port.
Frame synchronization is achieved on the port.
(continued)
308684-B Rev 00