Nortel Versalar 15000 Installing And Maintaining page 84

Installing and Maintaining the Versalar Switch Router 15000
Ensure that the slots in the Versalar 15000 flanges align with the holes in
3.
the rack.
If the holes in the rack's vertical supports are not threaded for cagenut screws,
insert a cagenut in 8 locations. (See
Mount the vertical flanges on the Versalar 15000 as shown in
4.
Holding the Versalar 15000 in position, align the flanges with two holes
5.
on each side of the vertical rack support
It is easiest to complete this step with two people. Make sure that the hole
pairs on either side of the vertical support match horizontally.
Insert a cagenut screw through each flange hole and into the
6.
corresponding hole in the rack.
Tighten each cagenut screw with a Phillips screwdriver.
7.
2-22
Figure 2-9.)
(Figure 2-10).
Figure 2-9.
308684-B Rev 00