Nortel Versalar 15000 Installing And Maintaining page 145

To connect a modem to the Versalar 15000:
1.
Table 4-4.
Setting
Clear to send (CTS) signal
Data terminal ready (DTR) signal
Data carrier detect (DCD) or
received line signal detection
(RLSD)
Data set ready (DSR) signal
Ready to send (RTS) signal
Synchronous/asynchronous mode
Auto answer
Local character echo
Supervisory functions
Baud rate
Data bits
Stop bits
Parity
308684-B Rev 00
Installing Processor and Interface Cards and Connecting Equipment
Turn on and configure the modem, using the parameters in
Refer to the modem documentation for instructions.
Modem Settings
Value
On
Modem will only connect if the DTR signal is
present. If the DTR signal is not present, the
modem will disconnect.
On while the carrier is present. The Versalar
15000 uses DCD to detect modem connect and
disconnect.
On
Ignored
Asynchronous
Answer on two rings when DTR is active.
Off
Off
9600
8
1
None
Table 4-4.
4-33