Turning The Versalar 15000 On And Off; Turning The Versalar 15000 With A Dc Power Source On And Off - Nortel Versalar 15000 Installing And Maintaining

Turning the Versalar 15000 On and Off

The following instructions are for a Versalar 15000 with a DC power source and
for a Versalar 15000 with the AC power unit installed.

Turning the Versalar 15000 with a DC Power Source On and Off

To turn on and off the Versalar 15000 with a DC power source:
1.
2.
3.
Figure 5-1.
308684-B Rev 00
Verify that a power module is installed in the left power module slot as
you face the front of the Versalar 15000.
If the Versalar 15000 is connected to the DC power source, make sure
that the circuit breaker in the rear of the chassis is in the on (1) position.
If the Versalar 15000 has two power modules, make sure that both circuit
breakers are in the on position.
Press the power switch to the on (1) position
the bezel to turn the switch on. You can access the switch with the bezel
on.
Versalar 15000 Power Switch
Front of chassis
Power switch
Operating the Versalar 15000
(Figure 5-1). Do not remove
VRS0046A
5-3