Verifying Correct Operation - Broadcom Brocade G720 Hardware Installation Manual

G720-Install-IG101 Installation Guide
connected to the fabric after it has been powered on and the default domain ID is already in use, the fabric segments.
To find the domain IDs that are currently in use, enter the fabricShow command on another switch in the fabric.
Perform the following steps to modify the domain ID:
a) Disable the switch by entering the switchDisable command.
b) Enter the configure command. The command prompts display sequentially; enter a new value or press Enter
to accept each default value.
c) Enter y after the Fabric param prompt.
Fabric param (yes, y, no, n): [no] y
d) Enter a unique domain ID (such as the domain ID used by the previous switch, if still available).
Domain: (1..239) [1] 3
e) Complete the remaining prompts or press Ctrl+D to accept the remaining settings without completing all the
prompts.
f) Re-enable the switch by entering the switchEnable command.

Verifying Correct Operation

Perform the following steps to verify correct operation of the device:
1. Check the LEDs to verify that all components are functional.
2. Verify the correct operation of the device by entering the following commands from the workstation.
Command
errDump
fanShow
historyShow
psShow
switchShow
tempShow
The switchShow command provides the following information about the device and ports status.
G720switch:admin> switchshow
switchName: E_146156_C5c_LS1
switchType: 181.0
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 156
switchId: fffc9c
switchWwn: 10:00:d8:1f:cc:12:c0:cd
zoning: ON (fos6k)
switchBeacon: OFF
FC Router: OFF
Fabric Name: FID1
HIF Mode: OFF
Allow XISL Use: ON
Broadcom
Displays any errors
Displays fans status and information
Displays the device history
Displays power supply status and information
Displays switch status and information
Displays temperature status and information
®
Brocade G720 Switch Hardware Installation Guide
Description
G720-Install-IG101
51