Setting The Time Zone - Broadcom Brocade G720 Hardware Installation Manual

G720-Install-IG101 Installation Guide
•
mm: Specifies the month. Valid values are 01 to 12.
•
dd: Specifies the date. Valid values are 01 to 31.
•
hh: Specifies the hour. Valid values are 00 to 23.
•
mm: Specifies the minutes. Valid values are 00 to 59.
•
yy: Specifies the year. Valid values are 00 to 37 and 70 to 99. Year values from 70 to 99 are interpreted as 1970 to
1999; year values from 00 to 37 are interpreted as 2000 to 2037.
device:admin> date
Thu Dec 22 14:05:10 UTC 2016
device:admin> date "1222150617"
Thu Dec 22 15:06:00 UTC 2017

Setting the Time Zone

The default time zone is Coordinated Universal Time (UTC). The time zone must be set only once because the value is
stored in nonvolatile memory. Use the following procedure to set the time zone.
1. Log on as admin.
2. Use the tsTimeZone --interactive command and follow the prompts, or enter the tsTimeZone -[hour-
offset ,minute-offset ] command as follows:
For Pacific Standard Time, enter tsTimeZone -8,0 .
For Central Standard Time, enter tsTimeZone -6,0 .
For Eastern Standard Time, enter tsTimeZone -5,0 .
Table 8: tsTimeZone Command Parameter Selection for the U.S. Time Zones
Atlantic Standard
Atlantic Daylight
Eastern Standard
Eastern Daylight
Central Standard
Central Daylight
Mountain Standard
Mountain Daylight
Pacific Standard
Pacific Daylight
Alaskan Standard
Alaskan Daylight
Hawaiian Standard
Broadcom
Local Time tsTimeZone Parameter (Difference from UTC)
-4,0
-3,0
-5,0
-4,0
-6,0
-5,0
-7,0
-6,0
-8,0
-7,0
-9,0
-8,0
-10,0
®
Brocade G720 Switch Hardware Installation Guide
G720-Install-IG101
49