Change Product - Loma Superscan Micro ISC Manual

MENUS A to Z
L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
In order to change the running product press the [CHANGE] key, then use the [ ] or [ ] to make
your selection. Finally, press the [ENTER] key for the selection to take effect.
Warning Messages:
+CHANGING TO+
+NOT CALIBRATED+
6

CHANGE PRODUCT

ANY DISPLAY
SETUP CALIBRATE
This message is always displayed to indicate that a product change is
taking place. The new product name and number is displayed on the
next display.
This message indicates that the selected product has never been
calibrated. To rectify this position go to the Product Setup menu and
make sure that the entries are correct before performing a full calibrate.
I S C
ENTER
RESULTS
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR