Manual Setup - Loma Superscan Micro ISC Manual

L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
Press the [ENTER] key to move into the Manual Setup menu, which will allow the calibration
parameters that are automatically derived from an update or full calibrate to be manually adjusted.
Notes:
Under normal operating conditions this menu will be disabled, as there is no need to carry out manual
adjustment to these settings which are set during the commissioning procedure.
If this menu is enabled, it will appear at the bottom of the calibrate menu.
Refer to the Principles of Operation section and to the individual entries of this menu (Working Mode,
Working Mode Lock, Minimum Threshold, Maximum Threshold, Threshold, Compensation, Head
Power and Head Lock), for details of how these adjustments can affect the operation of the machine.

MANUAL SETUP

MANUAL SETUP
SETUP
CALIBRATE
I S C
ENTER
RESULTS
MENUS A to Z
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
35