Configuration - Loma Superscan Micro ISC Manual

L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
This menu contains details of machine configuration, and usually only requires adjustment during
machine commissioning. Refer to Commissioning section of this manual if adjustments are required.
Press the [ENTER] key to move into this menu.
Notes:
Once the Configuration menu has been entered the detector will stop detecting and the Run Detect
LED will go out.
If the detector suffers from memory corruption it will reset itself automatically into the top of this
menu showing the message +NOT DETECTING+. Under these circumstances please consult your
nearest LOMA Service Centre.
If BATCH mode operation for PV Test is selected then the Configuration menu cannot be entered
unless the PV Test operation is turned off in the User Options menu.

CONFIGURATION

CONFIGURATION
SETUP
CALIBRATE
I S C
ENTER
RESULTS
MENUS A to Z
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
11