"Fe Size" - Loma Superscan Micro ISC Manual

MENUS A to Z
L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
FE SIZE is a product relative entry. It is used to enter the ferrous test wand size which is to be
prompted for when a PV Test is actioned.
Test wand sizes can be entered up to 10.00mm this allows entry of all the standard available Loma
test wands. An entry must be made to ensure the ferrous test wand is prompted for during a PV Test.
Leaving the entry at the default value of 0.00 mm will inhibit the prompt message.
Press the [ENTER] key, and then the [ ] and [ ] to set the required size.
Scope:
0.01 to 10.00 mm
Default:
0.00 mm
Notes:
This entry only appears if PV Test is enabled in the OPTIONS menu.
22

"FE SIZE"

*FE SIZE 0.00
SETUP CALIBRATE
I S C
ENTER
RESULTS
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR