Maximum Threshold - Loma Superscan Micro ISC Manual

MENUS A to Z
L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
When passing packs during a calibration cycle the system will check to make sure that the product
being used is not contaminated. If the threshold calculated for the product is greater than the
maximum threshold, the error message +BAD PACK+ will be displayed, and the calibration cycle
terminated.
Press the [ENTER] key and then the [ ] and [ ] keys to adjust the maximum threshold setting.
Scope:
min thrsh to 49990.
Default:
15000, 2000 for ISC.
Notes:
There should be no need to adjust the maximum threshold during normal operation: do not adjust the
value unless you are advised to do so by your LOMA Service Engineer.
This menu is only accessible if manual setup has been enabled in the User Options menu.
The manual adjustment increment or decrement is in steps of 10 units.
36

MAXIMUM THRESHOLD

MAX THRSH 15000
SETUP CALIBRATE
I S C
ENTER
RESULTS
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR