Flow Length - Loma Superscan Micro ISC Manual

L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
The flow length of the product is the length to flow along the conveyor, allowing for any permissible
skew of the product.
Press the [ENTER] key, and then the [ ] and [ ] keys to alter the flow length of the product.
Scope:
0 to 999mm
Default:
250mm
Notes:
Entering a value which is too short will cause the run error LED to flash when product flows,
indicating a touching packs error. Entering a number which is too long may also generate a touching
pack error (run error LED flashes) if the pack pitch is short.
This entry only appears if a Photo Eye (PEC) has been fitted to the conveyor system for product
registration purposes.

FLOW LENGTH

*FLOW LEN 250MM
SETUP
CALIBRATE
I S C
ENTER
RESULTS
MENUS A to Z
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
23