Loma Superscan Micro ISC Manual page 31

L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
head power is changed, if calibration occurs when there is no product, or if no products are seen
during an update calibration.
Notes:
This menu will only appear if first enabled in the User Options menu and product I is running.
In order to make sure that the correct head power is selected for product I, carry out a full calibrate on
all the products that will be run under ISC control and observe the head power derived for each. Then
set the head power for product I to the lowest value derived.
ISC may only be used for products which run reactive, i.e. exhibit a considerable product effect.
ISC LIMITS continued
ISC LIMITS
SETUP
CALIBRATE
I S C
ENTER
RESULTS
MENUS A to Z
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
31