Disable Reject - Loma Superscan Micro ISC Manual

L o m a S u p e r s c a n M i c r o
CANCEL
CHANGE
Description:
Pressing the [ENTER] key will cause the reject device to be "turned off" so that no product is
rejected, even if contaminated. This operation is not recommended, but may be useful at times of
maintenance.
Notes:
Once the reject device has been disabled, this menu item is replaced by the Enable Reject command.
This menu entry will not appear if the Reject Out of Run option has been enabled in the User Options
menu.
The Run Detect LED will go out when the reject is disabled and a run error will be logged (causing
the run error LED to illuminate and the auxiliary relay to be energised if it has been set to act as an
error indicator). If the auxiliary relay has been set to act as an in-run indicator, then it will be de-
energised when the reject is disabled.

DISABLE REJECT

DISABLE REJECT?
SETUP
CALIBRATE
I S C
ENTER
RESULTS
MENUS A to Z
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
15