Basic Specifications; Print Specifications - Star Micronics TUP500 Series Product Specifications Manual

3. BASIC SPECIFICATIONS

3.1. Print Specifications

(1) Printing Method:
(2) Dot Configuration:
(3) Dot Density:
(4) Printing Region:
R ec. Left
M argin: M in.
4m m
Notes:
1) This printer supports 45 to 82.5 mm paper widths.
2) Also, the standard position of printing to the paper width is center of the paper width.
3) The recommended value for print margins for the print regions is more the 4 mm on
4) The printer layout should have adequate left and right margins with regard to the paper
5) If using a head with a maximum print width of 80 mm, it is not possible to provide an
6) Before use, check the actual layout and the media that will be used to verify that they
(5) Printing Column Count:
The maximum print positions that can be printed on a maximum print width of 74 mm are shown in
the table below when 4 mm on each side is ensured for a total print margin of 8 mm on the left and
right sides on a maximum paper width 82.5 mm.
Maximum 49 Positions
Maximum 65 Positions
Maximum 37 Positions
Maximum 24 Positions
(6) Character Spacing
TUP500 Series Product Specifications
[M ax. P aper W idth] 82.5 ± 0.5 m m
[M ax. P rint W idth] 80 m m (640 D ots)
0.125m m
F ig. 3.1.4. P rint R egion
one side and more than a total of 8 mm.
width.
adequate print margin left and right, so it is possible that the print region will be off the
edges of the paper.
will work.
12 x 24 fonts
9 x 24 fonts
16 x 24 fonts
24 x 24 fonts *Only for Chinese Characters
Direct Line Thermal Printing Method
640 Dots/Line
8 dots/mm (203 dpi)
Max. 80 mm (See Fig. 3.1.4)
See table below.
3-1
R ec. R ight
M argin: M in.
4m m
0.125m m