Star Micronics TUP500 Series Product Specifications Manual page 16

(7) Paper Guide Setting: See the table below.
The paper guide can be adjusted in 2 mm increments. Lightly press the area near the Star mark
on the left side guide lever (see Fig. 3.3.1.7) and slide the lever. Position the leading end A of the
paper guide with the scale.
Adjust the paper width according to the representative values below.
1) Supports 82.5 mm paper:
2) Supports 79.5mm paper:
3) Supports 57.5mm paper:
4) Supports 45mm paper:
Notes:
1. If you use the printer with incorrect guide settings for the width of the paper used, paper
will skew, or paper jams can occur.
2. Carefully check the operations using your layout and print media.
Sliding
Direction
Sliding Paper
Guide
Lever
TUP500 Series Product Specifications
Position the end A of the paper guide to the scale a.
(Factory Setting)
Position the end A of the paper guide to the scale b.
Position the end A of the paper guide to the scale c.
(The Δ mark is a guide.)
Position the end A of the paper guide to the scale d.
(The diamond mark is a guide.)
A
Scale a
Scale b
Scale c
Scale d
Fig. 3.3.1.7 Adjusting the Paper Guide
3-9