Basic Specifications; Printing Specifications - Star Micronics TUP900 Series Specification Manual

3. BASIC SPECIFICATIONS

3-1 Printing Specifications

(1) Print Method:
(2) Dot Configuration:
(3) Dot Density:
(4) Printing Region:
3.75 mm
Notes 1) The mechanism can handle paper widths of 79.5 ±0.5 to 111.5 ±0.5 mm. However, it is
2) When using a paper width that is less than the maximum print width of the head (104 mm),
(5) Print Format:
(6) Character Space:
(7) Print Speed:
Note 1) Printing speed varies according to the processing speed of the controller and the temperature
(8) Paper Feed:
(9) Paper Feed Pitch:
(10) Line Width:
(11) Cuttable Sheet Length: 75 to 300 mm
(12) Print Head:
(13) Presenter:
(14) Emulation:
TUP900 Series Specifications Manual
Direct Thermal Line Printing
832 dots/line
8 dots/mm (203 DPI)
Maximum 104 mm (See figure below)
111.5 ±0.5 mm (Maximum paper width)
104 mm (Maximum print region, 832 dots)
0.125 mm
Fig. 3.1.4 Print Region
recommended that a print layout is set that allows plenty of print margin on the left and right
sides for the paper that is used. Also, the standard position of printing to the paper width is
center of the paper width.
Left and right margins in the printing region are recommended to be a minimum of 3.75 mm.
consider the recording paper feeding state so that the print region does not leave both edges
of the recording paper.
Maximum 69 columns (12 × 24 fonts)
Maximum 34 columns (24 × 24 Chinese character fonts)
(Only on Chinese character models)
Programmable
1) HS mode
2) LQ mode
3) HQ mode
4) Two Color Printing Mode
control using the head thermistor.
Thermal Mechanism Module
Presenter Module
0.125 mm (1 step on the paper feed pulse motor)
4 mm, 3 mm
Line Thermal Head
With Recovery Function
Star Line Mode
Star Page Mode
3.75 mm
Maximum 150 mm/s
Maximum 110 mm/s
Maximum 60 mm/s
Maximum 60 mm/s
Friction Feed Method
Roller Friction Feed Method
3-1
0.125 mm
Rev 0.01